-
Ashima Tower 128 Rajdanga Gold Park 2nd Floor Kolkata—700107 West Bengal India
| ¦ | Equipped with rebar sensor function | |
| Equipped with professional work on CPU | ||
| ¦ |
"Construction without cutting reinforcing bars" is possible for small-diameter drilling for seismic retrofitting work. The built-in "reinforcing bar detection software" automatically stops the core drill when it detects the reinforcing bars in the concrete. "Reinforcing bar detection software" can be installed on the previously purchased EHAC-130A. |
|
| ¦ | The return operation of the drill head is possible | |
| After the drilling work is completed, the drill head can be returned for up to 5 minutes. During this time, work such as tidying up is also possible. |
||
| ¦ | The set current value for automatic stop can be changed | |
| It is possible to lower the set current value when the drill load is small, such as with a thin blade or small diameter bit. It is also possible to increase the set current value when the drill load is large, such as in a deep hole or a large-diameter bit. |
||
| ¦ | Feed speed is mechanical 2-speed | |
| On the high-speed side, thin blades and small-diameter bits can be cut at a speed about 1.9 times faster than before. The low speed side is the same speed as our "EHAC-70A". |
||
| ¦ | Easy to attach to the clamp assembly | |
| The meshing part with the clamp assembly has been improved, eliminating the need for alignment and making installation easier. | ||
| Specification table | |||
| Model name | EHAC-130A | EHAC-130A Pro | |
| Power supply used | Single-phase AC 100-120V 50 / 60Hz | Single-phase AC 200-230V 50 / 60Hz | |
| Maximum power consumption | 75W | ||
| Maximum feed rate | CL-49 series | HI: Approximately 197mm / min LOW: Approximately 105mm / min | |
| CL-59 series | HI: Approximately 131mm / min LOW: Approximately 70mm / min | ||
| CL-74 series | HI: Approximately 155mm / min LOW: Approximately 83mm / min | ||
| Applicable core drill | |||
| SPF, SPN, SPZ, SPM, SPO, SPX type core drill E specifications (models other than SPX require conversion adapter set 15AC → 30AP) |
SPO-Pro, SPX-Pro E specifications | ||
| Rated current value of applicable core drill | 15A-30A | 16A or less | |
| Reinforcing bar sensor function | CC mode | Normal drilling | |
| FC mode (reinforcing bar sensor mode) |
Detects reinforcing bars and stops drilling Applicable core bit Nominal diameter 25-27 mm (3 ") |
||
| Dimensions (W x L x H) | 248 x 189 x 280 mm | ||
| mass | 8.2kg | ||
|
SHARE YOUR DETAILS
|
|
|
|
-For more information - Contact Us On - +91 9830899458
|
Please wait...